MIMAKI CG-60SR, Operation Manual

Page: 80 / 144

3-32
Confirm the following when failed in cutting correctly.
Check the sensor for the registration mark detection
1
Make sure that the plotter is in local
mode.
2
Enter the jog mode by pressing the jog key or
3
Turn on the Light Pointer by pressing the key.
4
Move the Light Pointer to the registration mark detection position by
pressing the appropriate ones of the jog keys
and
.
• Perform registration mark detection at a position 1mm or more away from the registration
mark.
• If you move the head and sheet manually, you cannot perform the right response check.
Be sure to perform it via the following operations.
• For conditions of already printed registration mark, refer to "Precautions in inputting data with
registration marks" ( P.3-13) .
• The setting values are kept in memory even when the power is turned off.
• The settings performed here for paper hold ON/OFF, shape of the registration mark and length
of the registration mark are reflected in the settings of “MARK DETECT”.
• The detection speed selected here will be used in the registration mark detection operations
that are executed from here on.
• The pointer offset value and sensor gain setting value selected by this operation are not
initialized by SETUP RESET operation.
• The registration mark detection sound is not made if the buzzer sound is set to OFF.
C U T 1 2 0 0 5 0 0 . 3 0
REMOTE
1 mm or
more away
Mark detection
position
Mark :
Type 1
Mark :
Type 2