MIMAKI CG-60SR, Operation Manual

Page: 120 / 144

4-2
Before taking a phenomenon as a trouble
Take appropriate remedies according to the table below.
If still the problem cannot be solved, contact MIMAKI or its dealer.
Phenomenon Cause Remedy
Power does not turn on.
The power cable is not
connected properly.
Connect the power cable to the
plotter and to the wall outlet
properly.
The plotter cannot perform
cutting (plotting).
The plotter name setting on the
host computer is wrong. Check the plotter name setting on
the host computer.
The interface cable is not
securely connected to the plotter
and the host computer.
Securely connect the interface
cable.
USB driver has not been
installed. Install USB driver supplied with
FineCut.
An error arises in the plotter
when the host computer sends
data to the plotter.
Command settings are wrong.
Correct the command settings
between the application software
and the plotter.
Plotter model setting is wrong.
Correct the plotter model setting
to [CG-60SR] on the application
software.
The plotter cannot detect the
sheet.
[** NO SHEET **]
A transparent sheet or a sheet
whose back side is black is used. Set the sheet sensor function to
OFF. (
P.3-65 )
By cutting operation, the sheet is
not cut, but perforated.
Screw for the tool holder is
loose.
Tighten up the screw.
The cutter blade protrudes
excessively. Adjust the protrusion of the blade
properly.
The tool condition is set to
[HALF]. Set the tool condition to [CUT1]
to [CUT5].
The blade is chipped or worn
out. Replace the blade with a new
one.
The blade does not rotate
smoothly. Replace the holder with a new
one.
The actual cut length is different
from the length specified on the
data.
The sheet feeding length varies
with the sheet thickness.
Correct the error margins by
executing the distance
compensation function.
(
P.3-6
)
Slippage of sheet arises in
cutting.
The pinch rollers and grit rollers
fail to securely retain the sheet in
position.
Check the position of the pinch
rollers and grit roller and adjust
them so that they securely retain
the sheet in position.
The clamp pressure (high or low
mode) has not been properly
selected.
Select the proper clamp
pressure. (
P.1-7
)
There is a slack in the roll sheet
so that the sheet being fed
meanders or skews.
Remove the slack in the roll sheet
and straighten the right and left
end faces of the roll when loading
the roll sheet on the plotter. Then,
start feeding the sheet.