MIMAKI CFL-605RT, Operation Manual

Page: 162 / 170

6-18
Display Cause Remedy
ERROR 401
MOTOR X
An excessive load was applied to
the Y bar driving motor.
Turn the power off once and turn it
on again.
If the same error message still
appears, contact your distributor or
a sales office of MIMAKI.
ERROR 403
X CURRENT
An overcurrent error in the motor in
the Y bar driving motor.
ERROR 402
MOTOR Y
An excessive load was applied to
the carriage driving motor.
ERROR 404
Y CURRENT
An overcurrent error in the motor in
the carriage driving motor.
ERROR 462
MOTOR

An excessive load was applied to
the

motor.
ERROR 464
 CURRENT
An overcurrent error in the motor in
the
 motor.
ERROR 461
MOTOR Z
An excessive load was applied to
the Z motor.
ERROR 463
Z CURRENT
An overcurrent error in the motor in
the Z motor.
ERROR 50a
Y ORIGIN
The plotter has failed to detect the
origin sensor.
Turn the power off once and turn it
on again.
If the same error message still
appears, contact your distributor or
a sales office of MIMAKI.
ERROR 511
Z ORIGIN
ERROR 532

ORIGIN
ERROR 533
X ORIGIN
ERROR 521
INIT MOTOR
Motor can not be initialized.
Turn the power off once and turn it
on again.
If the same error message still
appears, contact your distributor or
a sales office of MIMAKI.
ERROR 503
COVER OPEN
Protection door is open. Close the protection door.
ERROR C60
PenEncoder
The height of the pen cannot be
detected.
Turn the power off once and turn it
on again.
If the same error message still
appears, contact your distributor or
a sales office of MIMAKI.
ERROR C76
VAC / TILT
Excessive vacuum current. Turn off the plotter and vacuum.
Wait a while and turn them back on.
ERROR C75
REC.CUTTER
Appropriate cutting conditions not
set. Set appropriate cutting condition
values. (
P.2-11)
Worn blade Replace the blade with a new one.
(
P.1-18)
*** OFF SCALE *** Data extends beyond the effective
cutting area. (1) Stop processing ( P.2-25)
and clear data.
(2) Expand the effective cutting
area or enter data within the
effective cutting area.