MIMAKI CFL-605RT, Operation Manual

Page: 146 / 170

6-2
Now What Do I Do?
Problem Solution
Inadequate cutting
• When the cutter descends, cutting is incomplete,
although the blade protrudes by more than the
workpiece thickness.
The workpiece can be reliably cut by increasing the
pressure when the cutter descends.
• Set or increase the pressure offset value that is added
to the press value.
P.2-10 "Select the tool condition"
Cutting incomplete at the start or end point
(Reciprocating cutter)
• Cutting is incomplete at the positions where the cutter
descends or ascends.
Increase the start offset setting to move forward the
position where the cutter descends.
P.2-10 "Select the tool condition"
Increase the end offset setting to move backward the
position where the cutter ascends.
P.2-10 "Select the tool condition"
Cutting incomplete at the start or end point (Swivel
cutter) Set the over cut. ( P.3-25)
Circle start and end points do not match
• A circle start and end points can be displaced due to
the workpiece thickness and hardness.
Use circle

correction to correct for the displacement.
Grid lines torn along flutes of corrugate cardboard.
• Tearing can occur if the press value in the cutting
conditions is too high when grid cutting along the
flutes of corrugated cardboard.
(1) Align the corrugated cardboard flutes in the Y-axis
direction.
(2) Set the Y press value in the cutting conditions.
(
P.2-11)