OM-244 997 Page 23
E. Connecting Center And End Subframes To Rails And Installing Leveling Feet
1
Center Subframe
2
End Subframes
Use 16 bolts AA and 16 locknuts ZZ
at each angle bracket as shown to
connect center and end subframes
and rails.
Tighten all bolts and locknuts.
3
Leveling Foot
Install six leveling feet to bottom of
leg assembly tubes.
Do not tighten leveling feet at this
time.
Tools Needed:
1
2
2
AA and ZZ
1/2 in.
hex bit 3/16 in.
3
Attention:
If the welding table has two solid tops and no optional tool chest, proceed to Subsection J.
If the welding table has two solid tops and an optional tool chest, proceed to Subsection H.
If the welding table has a solid top and an X-pattern top and an optional tool chest under the dust tray, proceed to
If the welding table has a solid top and an X-pattern top and no optional tool chest or an optional tool chest under the
