OM-244 997 Page 31
5-3. Installing Optional Dust Tray
1
Dust Tray Rails
Use the supplied four bolts AA and
four locknuts ZZ and install dust
tray rails to the welding table. Be
sure that dust tray rails are on the
inside of the subframe assemblies.
Tighten all bolts and locknuts.
2
Dust Tray
Install dust tray into rail slides as
follows:
Tilt rear of tray down and lift front of
tray up.
Place flange on rear of tray behind
angle iron support.
Lower front of tray until
approximately level.
Slide tray into position.
Tools Needed:
1/2 in.
hex bit 3/16 in.
2
1
Side View
AA and ZZ
2
