38
Remove Bagger From Bag
Tunnel Clean Out
1. Using the release valve or valves on the hydraulic hand pump, slightly release the cable brake
pressure and move the bagger forward about five feet. Set the tractor brakes.
2. Send more product through the hopper to help loosen the packed product inside the tunnel. Al-
low as much product as possible to fall out of the tunnel and into the bag before bag is removed
from the tunnel.
Remove The Backstop
1. Place the backstop support feet into the pockets on the backstop to stabilize the backstop.
2. Release all pressure from the cable drum brake system.
WARNING
Backstop is heavy. Use care when moving backstop. Use equipment capable
of handling the backstop.
3. Unhook the cables from the backstop slings and move the backstop away from the bag.
4. Place the cables in the cable rewind guides.
5. Rewind the cables onto the drums. Use the hand crank or the hydraulic rewind. Push the cable
rewind control lever away from you to rewind the cables. The speed of the cable rewind can be
controlled by the position of the control lever. The control lever will hold in any of the positions.
Stop the cable end a few inches from the rewind guides.
Cable Rewind
Control Lever
Pull Bagger Forward Out Of Bag
1. Pull the bagger forward. The bag will slide off the tunnel. Grab each side of the bag on the end.
Walk the bag over itself pulling the product together. Bring the bag end forward.
2. Seal the end of the bag using either Master Seal strips or the double tie method. Refer to “Bag-
ging Instructions” for additional information.
NOTE:
No matter which method is used when sealing the end of the bag, loose plastic should be
weighted down. DO NOT use material that will be abrasive to the bag material.
