17
Prepare the Backstop
For ease of lacing the backstop, stand the backstop up and support with the backstop feet supplied
with the bagger.
Lace the backstop
1. Use the rope supplied with the bagger.
2. Start in the upper corner of the frame. Make sure you find the middle of the rope, Do Not cut the
rope.
3. Lace one end of the rope through the vertical rope eyelets going from the top to the bottom and
over to the other side of the frame and end in the other upper corner.
4. Weave the horizontal rope through the vertical rope. Start at the upper corner and weave the
rope through the vertical rope going from side to side and top to bottom. End at the lower
corner. Make sure you can untie the knots so you can tighten the ropes as required. See the
pattern below for correct lacing.
5. Stretch the rope tight and tie it off. Start by pulling the vertical lacing and then do the horizontal
lacing.
6. Tighten the ropes after a few bags. This keeps the bag from sitting down on the backstop frame.
NOTE:
Inspect the backstop rope occasionally, tighten or replace as needed.
Start
End
End
Weave Pattern
