Miller 500 BW, Operator'S Manual, Page: 68 / 96

64
Electric Control System
Filling The Rinse Tank
The 50 gallon rinse tank can be filled 3 different ways:
Fill Through Top Lid
1. Remove the lid from the top of the rinse tank. Fill the tank using a garden hose or similiar
means.
2. Replace the lid when complete.
Filling With Transfer Pump
Your sprayer is equipped with a 2" male fast fill connector and a ON/OFF valve (identified as “Valve
F”) located on the left side of the sprayer, directly behind the step.
Fill as follows:
1. Connect the fill hose to the 2" connector.
2. Charge the fill hose with water using the transfer pump.
3. Locate the electric rinse control switch on the control box on the tractor. Move the switch to
“Rinse Water” or “Rinse Tank” (depending on which control switch your sprayer has).
4. Slowly open the “Fast Fill” valve marked as “Valve F” and let run until rinse tank is full. Turn
off “Fast Fill” valve. There is a breather hose on the rinse tank to allow air to escape.
IMPORTANT: If you are filling with a high volume transfer pump, be careful NOT to open the
“Fast Fill” valve to full flow.
5. Disconnect the fill hose and replace the dust cap. Be careful removing the fill hose from the
connector - there could be some liquid in the line.
Filling With Sprayer Pump
Your sprayer has the ability to fill the clean water rinse tank its self by using the sprayer product
pump.
Your sprayer is equipped with a 2" male fast fill connector and a ON/OFF valve (identified as “Valve
F”) located on the left side of the sprayer, directly behind the step.
PRODUCT
TANK
OFF
ON
RINSE
TANK
E
F
OFF