Miller 500 BW, Operator'S Manual, Page: 59 / 96

55
Chemical Inductor (Optional)
The 5 gallon Chemical Inductor is an optional accessory and is mounted on the front left corner of
the spray platform. The chemical inductor is used to add chemical to the product tank from ground
level.
DANGER
Handle ALL agricultural chemicals with care. Use chemicals ONLY as directed
on the manufacturer’s warning label.
Wear protective clothing (such as goggles, rubber or chemical resistant gloves
and a respirator) while handling chemicals. Keep protective clothing clean and
in good condition or discard.
Wash hands and face thoroughly with clean water after handling chemicals.
Never eat, smoke, drink or put hands to mouth before washing.
Follow these procedures to properly use the chemical induction system:
1. Sprayer product tank MUST have at least 50 gallons of water.
2. Check that the emergency shut off valve located under the product tank is OPEN.
3. Start the product pump and run at rated speed.
4. OPEN the Chemical Fill Control valve.
5. If you are going to use the measuring marks on the chemical inductor tank to measure the
amount of chemical being added, make sure the valve on the bottom of the chemical inductor
tank is CLOSED. Add desired amount of chemical, then OPEN the valve at the bottom of the
chemical inductor tank. The chemical will be transferred from the chemical inductor tank to the
product tank.
NOTE: Poly tanks can vary in size and expand and contract from hot to cold weather. It is not
recommended to use the measuring marks on the chemical inductor tank for precise measuring.
If you do not need to use the chemical inductor tank to measure, you can OPEN the valve at the
bottom of the chemical inductor tank prior to adding the chemical. The chemical inductor will trans-
fer the chemical to the product tank as you are filling.
Chemical Inductor
Tank
Chemical Inductor
Tank Cover
Chemical Fill
Control Valve
Close This Valve To
Measure Chemical