18
The ProCast Mio can be mounted on the optional SMS-Mio shockmount, which you can use to greatly
reduce any noise transmitted through the mic stand. The shockmount is especially useful in reducing the
problems caused by a boomy soundstage, for example when miking overhead cymbals, or even in the
studio with talent that likes to move a lot on a floor that may not be as solid as it should be..
• To use the ProCast Mio with its shockmount, screw the
shockmount on a solid mic stand. If you are using a US
standard 5/8-inch mic stand, remove the Euro adapter
by unscrewing it from the shockmount.
• Once the shockmount is mounted to the stand, line
up the bottom threaded section of the ProCast Mio to
the holder and slowly rotate the bottom thumbscrew
clockwise until it screws on hand tight. Be careful not
to cross thread the screws.
• You can loosen the bottom thumbscrew slightly to
make left and right adjustments to the mic, and then
re-tighten it once it’s in place.
• Loosen the thumbscrew to set the microphone angle
and then tighten once it’s in place.
Installing the Optional SMS-Mio Shockmount
by
by
Summary of Contents for ProCast Mio
Page 1: ......
