Configuration MC130x
Users Manual Rev. 2.1
6 Configuration
The MC130x has 15 FPGA registers, r1..rf
h
, each 10 bit wide,
eight D/A registers, a1..a8, 8-bit wide, and one clock select regis-
ter, 4 bit wide.
The contents of all the above registers is called a profile. There is
space in non volatile memory for 6 profiles: one camera profile, 4
user profiles and one factory profile.
Any change of a specific register through the serial interface is
immediately processed and written to the camera profile. This set-
ting is stored in a volatile part of the memory and gets lost when
power goes down.
After power-up the camera profile is loaded from the non-volatile
to the volatile part of the memory and is used to adjust the camera.
A load or write command exchanges data between the camera pro-
file and one of the four user profiles.
The factory profile can be read but not be written by any command.
All values are given in hexadecimal notation, e.g.: 0xff or 0ffh =
255.
6.1 Read serial number and firmware revision
The serial number and the firmware revision can be read with the
:v
command.
20