![background image](http://html.mh-extra.com/html/miele/plw-6111/plw-6111_operating-instructions-manual_1793072018.webp)
INSTALLATION
REV.0.01_COD.650184_A4
Page 18
A booster pump is required if the flow pressure is below 100 kPa (14.5 psi). If the pressure is
higher than 800 kPa (116 psi), a pressure reducer must be installed.
If water pressure is not within the specified range, contact Miele Service or an authorized service
technician for advice.
A shutoff valve with a ¾” threaded union must be provided on-site. The valve should be easily
accessible, since the water supply should be shut off whenever the machine is not in use.
WARNING
Do not overtighten the threaded unions on the hoses.
Information:
The machine is equipped with a safety system for the protection of drinking water and may
be connected to the water supply without a non-return valve, if national regulations permit.
If no hot water supply is available, the red coded inlet hose for the hot water connection
must also be connected to the cold water supply.
A Y-piece can be used to connect both hoses to the cold water supply.
Miele cannot be held liable for damage or injury caused by noncompliance with the safety
instructions and warnings.
Non-compliance with the above conditions will render the warranty invalid.
WARNING
When the machine is not in operation, always close the shutoff valves.