Miele G 7919, Operating Instructions Manual

Page: 108 / 132

Problem solving guide
108
Water intake fault
Problem Possible cause and remedy
The alarm tone is
sounding.
One of the following
messages appears in
the display:

Please turn on the tap The tap is turned off.
 Turn on the tap fully.

Insufficient water intake.
Turn on the tap fully. Refer
to operating instructions if
necessary.
Before rectifying the problem, you must:
 Switch the dishwasher off.
Water intake is restricted.

Turn on the tap fully and start the programme
again.

Clean the filter in the water inlet (see “Cleaning
and care – Cleaning the water inlet filter”).
 The water connection pressure is lower than
50 kPa.
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Installation – Drainage”).

Fault F18: A technical
fault has occurred. Switch
off the appliance, turn off the
tap and call Miele Service.
A technical fault has occurred.

Switch the dishwasher off.

Turn off the tap.
 Call Miele.
The following fault
message appears in the
display during the
SolarSave programme:
Intake temperature too low
The intake water has not reached the required
temperature of 45 °C (see “Installation – Water
intake”).
 Restart the programme.
 If the fault message appears again, select a
different programme.