Miele G 7919, Operating Instructions Manual

Page: 111 / 132

Problem solving guide
111
Problem Possible cause and remedy
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:
 Fault F601: A fault has
occurred. Switch the
appliance off and back on
again. Restart the
programme. If the fault
occurs again, call Miele
Service.
.
There is a fault with the AutoDos.
 Switch the dishwasher off and back on.
 Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see
“Detergents – Automatic dispensing/AutoDos”).
 Activate the AutoDos function and restart the
programme.
If the fault message appears again, there is a
technical fault. You can continue to use your
dishwasher by deactivating automatic dispensing in
the Extras menu of a programme and manually
dispensing the detergent via the detergent
compartment.

If you wish to use automatic dispensing again,
contact Miele.
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:
AutoDos maintenance
required. Please check
AutoDos system.
The dishwasher does
not switch off at the end
of the programme.
The dishes may not be
clean because an
insufficient amount of
detergent was
dispensed.
The
AutoDos function is
automatically
deactivated during the
programme sequence.
An empty PowerDisk has been inserted or the
AutoDos is blocked by residual detergent. Detergent
dosage is insufficient.
The
AutoDos function was automatically deactivated.

Switch the dishwasher off and back on.
Multiple messages appear in the display.

Clean the detergent chute of the AutoDos (see
“Cleaning and care - Cleaning the AutoDos”).
 Clean the lower spray arm (see “Cleaning and care
- Cleaning the spray arms”).
 Confirm each message with OK .
 Activate the AutoDos function by confirming the
message AutoDos available using OK .
 Restart the programme.
The programme duration will be extended by up to
2.5 hours to flush out the AutoDos detergent outlet.