Plumbing
Connection to the water inlet
Water in the dishwasher must not
be used as drinking water.
The dishwasher may be connected to
a cold or hot water supply, max. 60 °C.
When connected to a hot water supply
all programme stages which would
otherwise be carried out with cold
water (pre-wash and interim rinse) will
be carried out with hot water.
The inlet hose is approx. 1.5 m long;
a longer hose (4 m) may be bought
from the Miele Spare Parts Dept.
A stopcock with a 3/4" male thread
must be provided on site.
The dishwasher is constructed to
comply with DVGW regulations, and
may be connected to a suitable sup-
ply without an extra non-return valve
if national regulations allow this.
The water pressure (flow rate at the
take-off point) must be between 0.3
and 10 bar pressure.
If the water pressure is too high, a
pressure reducer valve must be fitted.
The water inlet hose must not be
shortened or damaged in any way,
(see following illustration).
Connect the inlet hose with the
“Waterproof-System” preferably verti-
cally so that the hose exits from the
bottom of the "Waterproof valve" box.
If this is not possible, it can be in-
stalled horizontally, but
it is essen-
tial
that the main body of the "Water-
proof valve" box is above the hose
exit (see illustration). The ’lightning’
power symbol should be above the
water flow ’arrow’.
Plumbing
79
Summary of Contents for G 673
Page 2: ...2 ...
Page 4: ...Guide to the appliance View of the machine Control panel 12 Guide to the appliance 4 ...
Page 59: ...Installation instructions 59 ...
Page 83: ...83 ...
