![background image](http://html.mh-extra.com/html/miele/62858350usa/62858350usa_operating-instructions-manual_234499154.webp)
Installation
*INSTALLATION*
154
Installation and alignment
Please refer to the installation diagram provided.
In order to reduce the risk of water damage, the area around the
machine should be limited to furniture and fittings that are designed
for use in commercial environments.
The machine must be stable and horizontal.
Any unevenness in the floor level can be compensated for by adjust-
ing the two front feet. The feet height can be adjusted by a maximum
of 1/3" (8 mm).
With the feet screwed in the machine can be rolled backwards or for-
wards on fitted castors. To do this the machine must be raised up
slightly at the front.
Do not lift the machine by the control panel or the drawer in the
side unit.
This could damage them.
Some metal parts pose a risk of injury/being cut.
Wear cut-resistant protective gloves when transporting and setting
up the machine.
For transport by means of a hand truck, the machine must be in
its original packaging or placed on a stable, continuous support.
Otherwise, components in the base of the machine can be dam-
aged.
The machine is suitable for the following types of installation:
- Freestanding.
- Slot-in:
The machine can be installed beside other machines or furniture or
in a suitable niche. The niche must be at least 35 7/16" (900 mm)
wide and 27 9/16" (700 mm) deep.
- Building under:
The machine can be built under a continuous countertop or the
draining board of a sink. The space provided must be at least
35 7/16" (900 mm) wide, 27 9/16" (700 mm) deep and
32 5/16" (820 mm) high.
Freestanding machines or machines installed in a niche must have
the lid fitted.
23 3/8“ (60 cm) or 27 9/16” (70 cm) deep lids with additional side
wall extensions are available from Miele.