Frequently asked questions
142
Problem
Possible cause and solution
Fault 578
The peak-load cut-out has lasted longer than 3 hours.
Have your electrical system and your energy manage-
ment system tested by a suitably qualified person.
Process-related faults and messages
Problem
Possible cause and solution
Insert a new coarse filter
The maximum permitted operating hours for the coarse fil-
ter have been reached.
Replace the coarse filter with a new one.
Reset the operating hours counter for the coarse filter.
Change HEPA filter
The maximum permitted operating hours for the HEPA filter
have been reached.
Replace the HEPA filter with a new one.
Reset the operating hours counter for the HEPA filter.
Drying during program deacti-
vated
Drying cannot be selected at the start of a program be-
cause drying is not available for the selected program.
Start the program without drying.
Or
Have the drying parameters for this program adjusted by
Miele Service.
Wrong code entered
The PIN code entered is not the same as the code saved.
Enter the PIN code again.
Report the loss of the PIN code to Miele Service.
Test program: Test object
can now be removed
This is not a fault.
A test program is running to check performance. At certain
points in the program, the sequence is interrupted so that
samples can be taken.
Take a sample.
or
Wait. The program will continue automatically in approx.
30 seconds.
or
Continue the program without delay by pressing the
Start/Stop
button.
Program cancelled
This is not a fault.
A program which was running was canceled by the user.
The wash cabinet interior can be very hot.
When the door is opened, hot steam and process chemi-
cals can escape. Protective measures for personal safety
must be observed.
