Middleby CTX GEMINI Series, Owner'S Operating And Installation Manual

Page: 23 / 58

23
3. Programming the MenuSelect
TM
control on DZ33I ovens
The DZ33I oven contain one MenuSelect
TM
control. Through this control you are capable of programming all four heating
elements as well as the conveyer motor speed.
This oven has four heating zones as shown in Figure 3-5
Figure 3-5
The oven controller controls all functions of the oven. To operate the oven the controller must be programmed. The
following pages contain a step by step “hands on” programming exercise. We invite you to program your oven by
following the examples.
NOTE: This exercise assumes first time start after installation. Programming from the factory is 200
0
F (93
0
C)
temperature settings and 2 minute cook times.
a. Turn Oven Deck ON
1. Turn ON the main disconnect switch at the wall box.
Displays Reads
NOTE:
The date and time may be different from shown values. The date and time will be set later in this tutorial.
2. Turn oven ON/OFF switch ON.
b. The control is for programming, and must be unlocked to program.
1. When trying to program the control it will ask for a code.
2. In order to enter the program mode the code
1397 must be entered.
3. By entering this code the programming modes are enabled and will remain open for a period
of 30 seconds. After this time period the keypad will then ask for the code again.
4. After entering the code number press a preset program button (program number 0 through 9)
and set the top temperatures, bottom temperatures, and cook time values.
5. After the desired preset values are set, the control will automatically retain this information till
the program is changed.
NOTE: Do not lose the code number (1397) or you will not be able to change your program if needed.
c. Setting the preset MenuSelect
TM
temperatures in all four zones and the oven cook time.
Step Press Key Display Reads
1.Select preset menu key to be
Programmed