Page 26
INSTALLING THE GROMMETS (OPTIONAL)
1. Determine the desired locations for your grommets (G) on the woodkit (A). (
FIGURE AH
)
NOTE
: While you may install the grommets in any location where you would like cables to exit the
woodkit (A), pilot holes are located on the bottom inside to easily align with the existing holes in the
frame (B), if desired.
FIGURE AH
FIGURE AJ
FIGURE AK
NOTE
: This specific cutting procedure should be
followed carefully to avoid any chipping or splintering
on your woodkit (A).
2. Use power driver and the drill bit tip on a 1½” hole
saw to partially drill through the woodkit from the
pilot holes (or your desired locations) on the inside
of the woodkit (A) as shown. (
FIGURE AJ
)
3. Use power driver and hole saw to carefully finish
the grommet hole cut(s) from the outside of your
woodkit (A) as shown. (
FIGURE AK
)
Inside Surface
of Woodkit
Outside Surface of
Woodkit
Pilot Holes on the
Bottom of the Woodkit
(In Each Bay)
Holes on the Bottom
of the Frame
(In Each Bay)
Drill until bit tip
just breaks the
outside woodkit
surface.
B
A
A
A
Summary of Contents for C3 1-bay
Page 38: ......
