Middle Atlantic Products C3 1-bay, Instruction Sheet

Page: 16 / 38

INSTALLING THE SLIDE-OUT RACK OPTION (C3-TECHKIT4-SO)
TIP : After installing the slide-out rack option, you can remove the rack from the sliders, dress your rack
on a close bench or table, and then re-attach your rack onto the sliders. Remove the slide-out rack from
the sliders using the first step in “Installing Lever Lock™ Option (LLOCKSWRF-KIT) Inside Slide-Out
Rack Option” on page 18.
1. Install the power strip inside of the frame as explained in “Installing the Power Strip Inside the Frame
for Rack Options” on page 15.
2. Hook the shovel lances on the brackets of the partially pre-assembled slide-out rack (K) into the
rectangular set of holes on the frame (B, shaded) as shown. ( FIGURE M )
3. With the shovel lances hooked in the holes, push downward on the brackets until the rack locks into
place.
NOTE : Verify the torque on your power driver is on the lightest setting and only increase as necessary.
4. Use a power driver, #2 Phillips bit, and (2x) 8-32 x 5/16” thread forming screws (N) to secure the rack’s
brackets to the frame as shown. (
FIGURE N
)
Page 16
FIGURE M
Rectangular holes on
the frame for attaching
the brackets.
Shovel lances
on back of rack
brackets.
FIGURE N
Hole on the bracket
lines up with hole on
frame for screw.
NOTE : Upward view
of slide-out rack option
attached to frame.
Slide-Out Rack Handle
N
K
B