10. Without removing the bolt and washer on the wall from step 6 (previous), team lift and remove the
frame (B) from the wall and carefully set it aside.
11. Use a power driver and ½” drill bit to drill hole locations marked on the wall from step 8
(previous).
12. Insert remaining SNAPTOGGLE anchors (D) into each of the drilled holes as described in steps
2, 3, 4, and 5 (previous).
13. Team lift your frame (B) again and work the bolt and washer on the wall through the top keyhole
(top-left keyhole on the 2- and 4-bay models) on the frame.
NOTE
: The frame top and bottom are identical and, therefore, reversible.
14. Using the bolt as an anchor point, carefully slide the frame keyhole slots in line with all the anchors.
Page 12
9. With the frame still in position, use a pencil to mark the remaining keyhole slot locations, in line with
the nearest wall studs (where applicable), based on 1-, 2-, or 4-bay models, as shown. (
FIGURE H
)
NOTE
:
• Keyhole slot locations must align with wall studs (where applicable) for proper support.
• If securing to cinderblocks, avoid drilling into webs and sides as shown. (
FIGURE D
)
• If your installation requires additional measurements and frame details, refer to the technical
specification (96_01258_C3) at www.middleatlantic.com.
SECURING THE FRAME TO A WALL WITH STEEL STUDS OR CINDERBLOCKS
(CONTINUED)
FIGURE H
Remaining keyhole slot marking ranges
(3x, shaded) on 2-bay model.
Remaining keyhole slot marking ranges (7x, shaded) on 4-bay model.
Remaining keyhole slot marking
ranges (3x, shaded) on 1-bay model.
WARNING:
Total keyhole slot locations specified in these instructions are the minimum anchor
points required when securing the frame to the wall.
AVERTISSEMENT:
Les emplacements de serrure totaux spécifiés dans ces instructions sont
les points d'ancrage minimum requis lors de la fixation du cadre au mur.
NOTE
: You must drill into 2 separate
steel studs (where applicable) when
securing the 1-bay model.
NOTE
: You must drill into 2 separate steel
studs per bay (where applicable) when
securing the 2-bay model.
NOTE
: You must drill into 4 separate steel
studs per bay (where applicable) when
securing the 4-bay model.
Summary of Contents for C3 1-bay
Page 38: ......
