Middle Atlantic Products C3 1-bay, Instruction Sheet

Page: 11 / 38

Page 11
6. Use power driver and Phillips bit to partially screw a ¼”-20 x 2½” bolt (E) and ¼” washer (F) 3/4 of the
way into the anchor (leaving approximately ¼” (6 mm) of the bolt protruding from the wall).
7. Team lift your frame (B) and work the bolt and washer on the wall through the top keyhole (top-left
keyhole on the 2- and 4-bay models) on the frame.
NOTE : The frame top and bottom are identical and, therefore, reversible.
8. Using the bolt as an anchor point and a level on the top center of your frame (B), carefully slide the
frame into your desired position and make adjustments as necessary.
SECURING THE FRAME TO A WALL WITH STEEL STUDS OR CINDERBLOCKS
1. Use power driver and ½” drill bit to drill the hole for your top keyhole slot marking into the wall stud
(where applicable).
NOTE : If securing to cinderblocks, avoid drilling into webs and sides
as shown. ( FIGURE D )
2. Insert a SNAPTOGGLE
®
anchor (D) into the hole by
holding the metal channel
flat alongside the plastic
straps and sliding the
channel through the hole.
( FIGURE E )
5. Snap off plastic straps from each anchor by carefully
bending them toward the wall. ( FIGURE G )
3. Make the plastic straps handles even in order to
force the metal channel perpendicular to the entire
anchor. ( FIGURE F )
4. Secure each anchor by firmly sliding the plasic cap
along the straps until the flange of the cap is flush
with the wall.
FIGURE D
Web
Sides
FIGURE E
FIGURE F
FIGURE G
D
Metal
Channel
Plastic
Straps
Plastic
Cap
Even
Handles
Slide
Plastic
Cap
Bend
Straps
Toward
Wall