Microtronics myDatalogGauge 3G, User Manual

Page: 59 / 158

Chapter 8 Installation
5. Insert the activation module in the sensor recess of the myDatalogGauge 3G (see "Inserting the
activation module" on page 61).
6. Use the DeviceConfig configuration program to establish a Bluetooth connection (Bluetooth Low
Energy) between the myDatalogGauge 3G and your PC (see "Establishing a connection to a device
with Bluetooth Low Energy interface" on page 108).
7. Activate the synchronisation between myDatalogGauge 3G , DeviceConfig and the myDatanet
server. To do so, initially select the "Sync with server" checkbox and then click on the button illustrated
below. The checkbox and button are both located on the "Sync" tab of the DeviceConfig configuration
program (see ""Sync" tab" on page 112).
Note: The "Sync with server" checkbox is only displayed if your PC is already connected to the
Internet.
8. Wait until some measurement values have been recorded. The waiting time depends on the configured
record interval (see "Basic settings" on page 92) and the number of measurement values that you want
to take into consideration when calculating the zero point adjustment. If necessary, you can shorten the
record interval for this commissioning phase to reduce the waiting time. In this case, use the "Sync" tab
of the configuration program DeviceConfig (see ""Sync" tab" on page 112) to transfer the changed
record interval from the site to the myDatalogGauge 3G .
9. Trigger the synchronisation between myDatalogGauge 3G , DeviceConfig and the myDatanet server
to transmit the recorded fill level measurement values to the myDatanet server.
10. Wait until the DeviceConfig configuration program indicates that the synchronisation process is
complete.
Synchronisation completed
11. Click on the "Direct Report" symbol in the list of sites/applications to display the data saved on the
myDatanet server.
12. A so-called "report" is used to display the data stored on the myDatanet server (see "Reports" on page
131). Use the "Download" symbol to download the data of the displayed measurement value graphic
as a tsv file and calculate the average value of the fill level measurements (measurement value "Sensor
1" or "Sensor 2"). Detailed instructions on handling the reports is provided in myDatanet Server Manual
(805002).
Rev. 01 59