Micronics
U1000MKII User Manual
Issue 3.1 July 19
Page 15
2.2.8
U1000MkII-HM
Switch on the power to the Electronics Module. A Micronics start-up screen is displayed for 5
seconds followed by hardware and software version information.
You are then prompted to enter the internal diameter of
the pipe:
Use the
,
and
keys to change the value.
Press
to confirm the value.
Select the pipe material by using the
and
keys
to scroll through the list.
Press
to confirm the material.
Select the instrument setting using
.
The unit is preconfigured for Heating applications.
Press
to confirm the setting.
Select which side the electronics unit is installed using:
.
The unit is preconfigured for
Flow
.
Press
to confirm the setting.
Select the fluid using
.
Press
to confirm the fluid name.
The unit now shows the correct flow sensor separation (in
this case, “
D-3
”)
for the chosen values of pipe ID, pipe
material and fluid.
Make a note of the separation code.
All subsequent start-ups will use the same configuration. If the configuration needs to be changed
for any reason, use the password-controlled menu (see page 23).
Continue with the installation of the Sensor Assembly (see page 16).
Enter Pipe ID :
050.0 mm
Pipe Material:
Plastic
Instrument Type:
Heating|Chiller
Instrument Side:
Return|Flow
Instrument Fluid
Glycol|Water
Set Separation:
D-3
Summary of Contents for U1000MKII-FM
Page 2: ......
Page 55: ...Micronics U1000MKII User Manual Issue 3 1 July 19 Page 51 7 DECLARATION OF CONFORMITY...
Page 56: ......
