1HW)5$0(6HULHV6HUYHU3URGXFW*XLGH
0LFURQ(OHFWURQLFV,QF
,QVWDUG'ULYHLQWKH,QWHUQDO%D\
The internal peripheral bay has space for these possible drive combinations (height and quantity):
•
Four drives, each 1 inch high
•
Three drives, each 1.6 inches high
•
Two 1.6-inch drives plus two 1-inch drives
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove side system cover.
3. Disconnect the power and signal cables from all drives installed in the bay.
4. Remove and save the three screws holding the bay to the chassis.
5. Swing the bay out to the left of the chassis.
6. Slide the bay upward to disengage its tabs from the chassis.
7. Remove the bay from the chassis, and place it on an antistatic surface.
OM05076
Figure 14. Removing the Internal 3.5-inch Drive Bay
8. Remove the new drive from its protective wrapper and place it on an antistatic surface.
9. Record the drive model and serial numbers in your equipment log.
10. Set any jumpers and/or switches according to the drive manufacturer’s instructions.
11. Position the hard drive, component-side facing down, in the bay. Align the screw
holes in the drive with those in the bay, and secure the drive to the bay with four
screws (not supplied).
12. Reinstall the bay in the chassis: insert the tabs on the bay into their slots in the
chassis. Slide the bay downward until the tabs interlock with the slots.
13. Swing the bay to the right into the chassis.
14. Secure the bay with the three screws you removed earlier; tighten the screws firmly.
Summary of Contents for NetFRAME 2100 Series
Page 1: ......
Page 178: ...MAS001568 01 6 99 ...
