1HW)5$0(6HULHV6HUYHU3URGXFW*XLGH
0LFURQ(OHFWURQLFV,QF
OM06348
A
B
Figure 25. Removing a Termination Board
3. If your system has one processor and you are REPLACING it, leave the termination
board intact in the empty Slot 1 secondary connector. Remove the processor you
want to replace. See “Removing a Processor”.
4. If your system has two processors and you are REPLACING one or both, remove the
appropriate one(s). See “Removing a Processor”.
5. Remove the new processor from its antistatic package and place it on a grounded,
static-free surface or conductive foam pad.
6. Orient the processor so that the heat sink faces the center of the system board. Slide
the processor into the retention module. Ensure that the alignment notch in the S.E.C.
cartridge fits over the plug in Slot 1. Push down firmly, with even pressure on both
sides of the top, until the S.E.C. cartridge is seated.
7. To lock in the processor, push the latches outward until they click into place in the
retention module (A in Figure 26). The latches must be secured for proper electrical
connection of the processor.
8. Attach the small end of the power cable to the fan connector on the S.E.C. cartridge,
then attach the large end (B) to the three-pin connector on the system board (C).
Summary of Contents for NetFRAME 2100 Series
Page 1: ......
Page 178: ...MAS001568 01 6 99 ...
