1HW)5$0(6HULHV6HUYHU3URGXFW*XLGH
0LFURQ(OHFWURQLFV,QF
6WDUWLQJ6HWXS
You can enter and start Setup under several conditions:
•
When you turn the system on, after POST completes the memory test
•
When you reboot the system by pressing <Ctrl+Alt+Del> while at the DOS operating
system prompt
•
When you have moved the CMOS jumper on the system board to the “Clear CMOS”
position (enabled); for the procedure, see Chapter 5, under the heading “CMOS Jumper”
In the three conditions listed above, after rebooting, you will see this prompt:
Press <F2> to enter SETUP
In a fourth condition, when CMOS/NVRAM has been corrupted, you will see other
prompts but not
the <F2> prompt:
Warning: cmos checksum invalid
Warning: cmos time and date not set
In this condition, the BIOS will load default values for CMOS and attempt to boot.
6HWXS0HQXV
Setup has six major menus and several submenus:
1. Main Menu
•
Primary IDE Master and Slave
•
Secondary Master and Slave
•
Keyboard Features
2. Advanced Menu
•
PCI Configuration
⇒
PCI Device, Embedded SCSI
⇒
PCI Device, Slot 1 - Slot 4
•
Integrated Peripheral Configuration
•
Advanced Chipset Control
3. Security Menu
4. Server Menu
•
System Management
⇒
Server Management Information
•
Console Redirection
5. Boot Menu
•
Boot Device Priority
•
Hard Drive
•
Removable Devices
6. Exit Menu
Summary of Contents for NetFRAME 2100 Series
Page 1: ......
Page 178: ...MAS001568 01 6 99 ...
