Microlife BP W100-MAM Wrist, Manual

Page: 18 / 41

16
* Please immediately consult your doctor, if this or any other problem
occurs repeatedly.

If you think the results are unusual, please read through the
information in «Section 1.» carefully.
8. Safety, Care, Accuracy Test and Disposal

Safety and protection
• Follow instructions for use. This document provides important
product operation and safety information regarding this device.
Please read this document thoroughly before using the device and
keep for future reference.
• This device may only be used for the purposes described in these
instructions. The manufacturer cannot be held liable for damage
caused by incorrect application.
• This device comprises sensitive components and must be treated
with caution. Observe the storage and operating conditions
described in the «Technical Specifications» section.
• Protect it from:
- water and moisture
- extreme temperatures
- impact and dropping
- contamination and dust
- direct sunlight
« ERR 3 » No pres-
sure in the
cuff
An adequate pressure cannot be generated in
the cuff. A leak may have occurred. Check that
the cuff is correctly connected and is not too
loose. Replace the batteries if necessary.
Repeat the measurement.
« ERR 5 » Abnormal
result
The measuring signals are inaccurate and no
result can therefore be displayed. Read
through the checklist for performing reliable
measurements and then repeat the measure-
ment.*
« ERR 6 » MAM Mode There were too many errors during the
measurement in MAM mode, making it impos-
sible to obtain a final result. Read through the
checklist for performing reliable measure-
ments and then repeat the measurement.*
« HI » Pulse or cuff
pressure too
high
The pressure in the cuff is too high (over
299 mmHg) OR the pulse is too high (over
200 beats per minute). Relax for 5 minutes
and repeat the measurement.*
« LO » Pulse too
low
The pulse is too low (less than 40 beats per
minute). Repeat the measurement.*
Error Description Potential cause and remedy