Microcom 438TM, Operator'S Manual

Page: 225 / 231

438TM Operator’s Manual - 880049-0113 13-19
X 162 Set Advance/Retract Speed: This command is used to set the
advance/retract speed of the dispense commands (^D97, ^D98, ^D99, ^D111)
and uses the same speed table as the ^D46 command.
163 Read Current Sensor Status: This command is used to report the current
status of the printer’s sensors. This is useful in setup and/or troubleshooting.
164 Generate Data Matrix Barcode
X 165 Set the Reflective Dot2Gap Value: This is the distance of the reflective
sensor, that detects blackline registration marks, to the dot row.
187 238 and 338 Series 203dpi
276 238 and 338 Series 300dpi
468 438 203pi
730 438 300dpi
487 438T Series 203dpi
720 438T Series 300dpi
166 Generate 4-State Intelligent Mail Barcode
X 176 Generate Planet Code Barcode
X 177 Ethernet Option Board Configuration
1 Set IP Address (default is 192.168.200.3)
2 Set TCP port
3 Enable DHCP
4 Set NetBIOS Name
5 Set Gateway Address
6 Set Subnet Mask
7 Set MAC Address (only needed if replacing the CPU)
8 Display Ethernet Parameters
9 Save Ethernet Parameters
X 178 Set Pre Takeup Delay: This is used in conjunction with the Takeup code and
enablement on switch bank D26. Sets a delay by the value for “x” that
represents the number of steps the printer moves before running the takeup
motor. The range is 0 to 65535. If the delay distance is set to a value greater
than the label height, the takeup will not turn on.
X 193 Generate Aztec Barcode
X 194 Generate QR Code Barcode
Glossary