Microcom 438TM, Operator'S Manual

Page: 214 / 231

13-8 438TM Operator’s Manual - 880049-0113
1101 = Italian (7 bit)
1110 = British (7 bit)
1111 = US English (7 bit)
^AB ^D COMMAND
25 Software Bank Switch #5: A non-volatile command used to set the various
functions identified below.
^AB12345678
Position:
1
1 = Enable Single Button Error Clear; 0 = Disable
2 1 = Display >BUTTON PRESSED<; 0 = Disable
3 1 = TOF sensor is transmissive; 0 = TOF is reflective
4 1 = Enable TOF on Power-up; 0 = Disable
5 1 = Button is TOF; 0 = Button is Defined by SW#2 bit4
6 1 = Enable AutoLoad; 0 = Disable
7 1 = ATOF; 0 = AFF
8 1 = Enable Status Byte Mode; 0 = Disable
26 Software Bank Switch #6: A non-volatile command used to set the various
functions identified below.
^AB12345678
Position:
1
1 = Enable >TRAY FULL< response; 0 = Enable Test Pattern
2 Reserved
3 1 = Enable Pre-Stock Out Feature; 0 = Disable
4 1 = Enable >STOCK NOT LOADED< response; 0 = Disable
5 Reserved
6 1 = General Purpose I/O Enable; 0 = Custom I/O Enable
7 1 = Enable Takeup Control; 0 = Enable Cutter Control
8 Reserved
27 Software Bank Switch #7: A non-volatile command used to set the various
functions identified below.
^AB12345678
Position:
123
Reserved
456 Reserved
7 1 = Disable System Parameter Saving; 0 = Enable
8 1 = Enable Finish Mode; 0 = Disable