Microcom 428LT, Operator'S Manual

Page: 68 / 210

Chapter 5 Printer Commands
428LT Operator’s Manual - 880040-0200 5-25
011 – 3.25
111 – 4
7 Disable System Parameter Saving: When enabled, the printer will not save
the non-volatile system parameters on power downs. The ^A1^D143 will
continue to save system parameters.
1 = Disable system parameter saving
0 = Enable system parameter saving
8 Finish Mode: When enabled, the printer will finish printing the current label
as far as it can after a stock out error. The change will take place after a power
cycle or after the restart command. When a stock out occurs the printer will
finish printing the entire label if the LSY is less than the dot-to-gap distance. If
greater, it will continue printing for a distance equal to the dot to gap distance
OR until the label finishes; which ever comes first. The dot-to-gap value is
configurable using the D158 command. The error will be acknowledged at the
end of printing. This will work with all media (continuous, black line, and gap).
1 = Enable Finish Mode
0 = Disable Finish Mode
5.2.1.8 Software Switch #8
^AB ^D COMMAND
XX 28 Change SW8: Software Switch #8.
^AB12345678 ( each bit is represented by a numeric position number)
Position:
1
Enable Test Ticket: When this position is enabled, the printer will execute
the saved format stored every time that the button is pressed. For more
information regarding saved formats, please refer to SW #2
1 = Disable Test Ticket
0 = Enable Test Ticket
2-6 NOT USED:
7 Enable Reflective Stock Out: For stock out detection while printing, the LCB
must be set for continuous stock (LCB=2) and sw8 p7 must be set. For power
up stock out detection (when sw6 p4 set) just sw8 p7 must be set (since there
may not be a valid LCB in play).
1 = Disable system parameter saving
0 = Enable system parameter saving
8
NOT USED: