Microcom 428LT, Operator'S Manual

Page: 101 / 210

Printer Commands Chapter 5
5-58 428LT Operator’s Manual - 880040-0200
Printer Model Number Dot2Gap value
203dpi 224/424 468
300dpi 224/424 720
203dpi x24m 284
300dpi x24m 438
203dpi x28 264
300dpi x28 380
Table 5-3 Dot2Gap Values
^A
^D COMMAND
X 159 Brownout Reporting:
A brownout condition is a sag or drop in the supply voltage that dips below
16.4Vdc but does not continue to sag and perhaps goes back to the 24Vdc
supply voltage. The printer will attempt to update its configuration and
counters in this condition. Proper power sources should not normally have
situations were Brownouts are a frequent occurrence. The printer provides the
ability to monitor these types of conditions using the D159 command. The
D159 command provides a volatile or running total of the brownouts and a
non-volatile count that is saved.
0 After a power up, reports the “running” total of detected Brownouts.
1 Clears the “running” total or volatile brownout count
5 Reports the non-volatile brownout count stored in memory
255 Clears the non-volatile brownout count stored in memory