Microcom 428LT, Operator'S Manual

Page: 196 / 210

428LT Operator’s Manual - 880040-0200 12-13
sensor. If this value is not set correctly the printer may false sense a
registration mark or report an invalid >LOW STOCK< error.
^A
^D COMMAND
XX 91 Transmissive Detection Sensitivity: The ^Axx value sets the point (0-255) at
which the printer detects a diecut registration mark (gap) and/or blow-hole
using the transmissive sensor. The printer’s threshold default is a value of 30
for the transmissive sensor. If this value is not set correctly the printer may
false sense a registration mark or report an invalid >LOW STOCK< error.
XX
92 Set Starting Slice Number: This command adjusts the number of dot rows
that the printer will generate before the printer starts to print.
X
93 Load Control Code Recognition Status:
0 Enable control code recognition
1 Disable control code recognition
X 94 Set Slice Buffer Size: Sets the size of the slice buffer memory that is used by
the printer to generate images to be printed. If the slice buffer memory size is
set to low, the printer may start printing and then stop to process additional
slices before starting again.
2 88Kbytes
3 192Kbytes
4 256Kbytes
5 320KBytes
6 384KBytes
XX 95 Load Advance/Retract Distance: Used in conjunction with cutter and
dispense command. The ^Axx specifies the amount to advance after printing
and then retract to dot row. The count is given in dot increments.
XX 96 Load Advance Delay: The ^Axx specifies the amount of delay, in
Milliseconds, the printer waits before retracting to dot row in cutter and
dispense modes.
X 97 Tag/Tear Dispense Mode:
0 Disables Tag/Tear Mode
1 Advance after every label.
2 Advance after copies count.
3 Advance when idle.
X 98 Peel-n-Dispense Mode:
0 Disable Peel-n-Dispense
1 Enable Peel-n-Dispense