Microcom 428LT, Operator'S Manual

Page: 55 / 210

Printer Commands Chapter 5
5-12 428LT Operator’s Manual - 880040-0200
Table 5-2 Enquiry Responses
5.2 Printer Configuration Commands
The following commands are used to set up printer configuration. Most of these commands
are non-volatile and, therefore, do not need to be resent unless changes are desired.
Note: When the printer is in the DEFAULT MODE, factory settings control printer operation.
This provides a starting point for re-establishing communication with the printer so that user
settings may be sent to the printer. The statistics label printed when the printer entered the
DEFAULT MODE reflects current printer settings and not the factory default settings.
Text Mode Response
Byte Mode
Response
Definition
>RESTARTED< 1A Printer has been reset
>READY< 06 Normal condition
>CUTTER ERROR< 07 Cutter cannot rotate
>TAKE LABEL< 16 Printer is waiting for label to be taken
>LOW STOCK< 19 Media supply is low or out
>INPUT 1< 0E Input sensor #1 active
>INPUT 2< 21 Input sensor #2 active
>TRAY FULL< 09 Printed label tray is full
>PRINTER PAUSED< 10 Printer is paused
>TOF ERROR< 1F Top of Form is not sensed properly
>OVER VDD< 1E VDD voltage is out of operational range
>UNDER VDD< 1C VDD voltage is out of operational range
>OVER TEMP< 1D Print Head is too hot
>DATA ERROR< 15 Communication error
>STOCK NOT LOADED< 22 Printer power on without media installed.
>BUTTON PRESSED< C0
Print button configured to report message
when pressed.
>CODE 12< FF CRC value does not match stored value.
>BROWNOUT RECOVERY<
Printer entered and recovered from a
brownout power condition
>FAIL TIMEOUT<
Timeout failure occurred using the D149
Image Print Mode
>FAIL SIZE<
Incorrect size of the image was received
using the D149 Image Print Mode