Page 37
Operation
optoNCDT ILR 1191
9.
Operation
Insert connector in main connection port and interface.
Install and firmly screw Profibus and SSI connectors.
Protect all cable ends, which you don‘t use, before you turn on the power supply. So you avoid short
circuits.
The user is required to implement:
- the application-specific wiring,
- the application-specific parameterization of the Profibus, the slave address.
Turn-on the voltage supply for the sensor. The Status LED must light green.
Make sensor parameter settings via RS232/RS422.
Start the distance measurement.
Install the sensor using the pilot laser as part of preparative actions in the designated working site,
oriented onto the target and keep it in a stable position. The target to be measured should preferentially
have a homogeneous, white surface.
Lock the sensor.
The sensor provides a visible laser beam (pilot laser) for greater convenience in alignment. Its visibility is con-
ditional on the amount of ambient light present and on the type of surface of the target to be measured.
Reflector
Reflector
Reflector
Fig. 17 Measurement against a reflector
Summary of Contents for optoNCDT ILR 1191
Page 1: ...ILR 1191 300 Instruction Manual optoNCDT ILR 1191...
Page 6: ...Page 6 optoNCDT ILR 1191...
Page 63: ......
