Page 28
Installation and Mounting
optoNCDT ILR 1191
5.5
Profibus
Read this chapter, if you work with a ILR 1191-300(04) sensor.
Connection to the Profibus is accomplished via a 5-pole, B-encoded M12 male connectors. Use shielded
cables for connection.
Pin Assignment Profibus IN
Assignment Profibus OUT
1
n.c.
3
4
1
5
2
5 V
4
3
2
5
1
2
A
A
3
n.c.
Ground
4
B
B
5
Screen
Screen
For operation via Profibus, other Profibus participants may connect to the 5-pole male connectors (A-cable,
B-cable). The Profibus may terminate or continue at the 5-pole male connector Profibus OUT. Some kind of
termination device must always be provided at the end of the Profibus. Supply voltage for the bus termina-
tor is available at Profibus-OUT. The 5 V are electrically isolated from the supply voltage (VCC) and rated for
loads up to 100 mA. The termination impedance is available as an optional accessory.
Summary of Contents for optoNCDT ILR 1191
Page 1: ...ILR 1191 300 Instruction Manual optoNCDT ILR 1191...
Page 6: ...Page 6 optoNCDT ILR 1191...
Page 63: ......
