Page 42
Operation
MSC7401 / 7802 / 7602 Miniature sensor controller for inductive displacement sensors
5.
Operation
Before starting the measurement or making settings, let the controller with connected sensor warm up
for approx. 2 minutes while supply voltage is switched on.
i
Observe the operating instructions of the sensors used.
i
If a sensor is replaced, the channel must be re-parameterized and readjusted.
The parameter setup of the controller may either be performed via keys on the controller or via the sensor-
TOOL
. The output is then via the analog outputs or the RS485 interface
or the sensorTOOL.
