Micrel Confidential
12
June 2006
2180 Fortune Drive, San Jose, CA 95131, USA
•
(408) 944-0800
•
http://www.micrel.com
KSZ8862-16 MQL Demo Board User’s Manual
6
Getting Start for Demonstration
6.1
Power on the Demo Board
If user needs to update the OpenTCP driver, they can read the Chapter 7 to download the
update driver, otherwise user just connects the RS-232 serial cable between the PC and
the Demo Board. On the PC, open the Hyper Terminal and configure the speed to 38400
Bits/Second as shown in Figure 2, then plug in the 7.5V DC jack to power on the Demo
Board. Normally the Hyper Terminal window will display as shown in Figure 5.
Figure 5: Hyper Terminal Display after Power On the Demo Board
In this window, press “Enter” and type “=>hwhelp” to show all commands and
parameters that can read/write to registers, configure the chip, display MIB counters and
send packets, etc.
From this window, the software has assigned the IP and MAC addresses in the Demo
Board. IP Address: 192.168.1.1
Switch Host MAC Address: 08-00-70-22-44-55
