MICOM-3F/3T/3R HF-SSB Owner’s Guide
84
Selecting Radio Parameters
➤
To enter the Radio Parameters programming mode:
1. Enter the Radio Programming menu (page 79).
MICOM-3
RADIO
PROGRAMMING
CHAN
PRMT
OPTS
2. Press
PRMT
(F2).
MICOM-3
GET
STOR
ERAS
PWR
RADIO
PARAMETERS
LSB
I
The PRMT option in the Radio Programming menu provides the following options (see also Figure
6
):
•
BAUD
Select the data transmission rate:
•
1.2
– 1200 bps
•
2.4
– 2400 bps
•
4.8
– 4800 bps
•
9.6
– 9600 bps.
•
DPWR
Select the maximum transmit power for data transmission, that is, for a transmission
initiated by the data PTT. The available selections are:
•
LOW
25 W nominal
•
MED
62.5 W nominal
•
HIGH
100 W nominal
•
MAX
125
W
nominal.
The transmit power used in the other modes is independently selected for each
channel. If the selected data transmit power exceeds the transmit power configured
on the operating channel, the radio will use the lower channel transmit power.
•
MST
Enable/disable the sidetone heard in the speaker when you transmit using the
microphone.
•
AST
Enable/disable the heard in the speaker sidetone when you transmit using an
accessory connected through the rear panel.
•
PTBP
Enable/disable the transmission of a beep when the local push-to-talk (PTT) button is
released.
This beep is used to notify the other stations that the local (your) radio set has
stopped transmitting and returned to the receive mode: therefore, another radio can
start transmitting.
•
KBBP
Enable/disable the keypad beep. When enabled, a beep is heard whenever a valid
key is pressed.
•
TONE
Select the keypad beep level: high or low. The selection is relevant only when the
keypad beep is enabled.
