Meyra Optimus 2 2.322, Service Manual

Page: 54 / 76

54
9
8
1
2
3
SETTING THE SPEED FACTOR
Setting the wheelchair type automatically sets every-
thing and normally this setting fits if the components
bought correspond with your declaration.
Since the speed torque of the motors that are built into
the Sprint or Champ can vary from your declaration,
the final speed can be aligned over this factor.
Even when for example the motors or the power mod-
ule have been replaced on the wheelchair and the
wheelchair afterwards does not reach the accustomed
final speed, the final speed can be aligned through this
factor.
Values from 50 to 127 can be selected. In doing so an
adjustment by one step means a change of about 0.1
km/h final speed.
Proceed as follows:
1. Switch on the wheelchair.
– Place the programming foil.
2. Press the right and lower service key (2)+(3) simulta-
neously and keep them pressed.
– Additionally press the left service-key (1) and release
it again. – This switches the wheelchair off.
– Then release all keys.
3. Switch the wheelchair back on.
– After the initialisation phase the display shows <
HHH > as a signal that the adjustment modus has
been activated.
4. Press the joystick toward the back.
– The display shows the currently set speed factor,
e.g. 105.
5. Select the desired speed factor with the up- or down-
key (9) or (8).
6. For confirmation move the joystick backward.
– The program is ended and the display shows < HHH
> again.
7. Conclude adjustment modus, view chapter < Conclud-
ing adjustment modus >.