Meyra 1.163, Service Manual

Page: 54 / 80

1
3
2
4
54
Programming sequence
1. Remove the seat and rear revetment/battery
cover of the Scooter.
Power electronic < SOLO >
2. If required remove the plug out of the cover
in front of the programming socket (1). After-
wards insert the cable of the programming unit
or adapter cable.
Power electronic < S-Drive >
2. If necessary remove the cover of the electronic
and plug [2]. Afterwards pull the 4-pole plug (3).
Then insert the 4-pole plug of the programming
unit or adapter cable [4].
3. Switch the Scooter on.
☞
Note:
The programming device is automatically
switched on together with the vehicle.
4. Conduct the programming
☞
View chapter < Programming unit SP1 > or chap-
ter < PC-programming >.
5. After programming pull the plug of the pro-
gramming device.
Power electronic < S-Drive >
☞
Re-insert the 4-pole plug of the vehicle cable
(3).
6. Afterwards check the driving behaviour of the
scooter with the new parameters.
7. Reattach the cover, resp. press the plug back in.
☞
Note:
On all models with LCD-display in the operating
panel some parameters can already be changed
by "ON-Board-Programming".
☞
For this observe chapter < Operating panel in
the LCD-display >.
Model 1.163:
☞
A programming of model 1.163 is not planned.