Metrohm 2.792.0020 Basic IC, Instructions For Use Manual

Page: 23 / 197

2 Installation
792 Basic IC
14
x
Insert the cable permanently attached to the detector block
38 38 38 38 in one of the openings 5555 and the outlet capillary in one of
the openings 7777 of the rear panel 9999 .
x
Replace rear panel 9999 and screw to the 792 Basic IC using the
four knurled screws 8888 .
3 Connect detector block
x
Plug the gray connecting cable permanently attached to the
detector block 38 38 38 38 into connection 15 15 15 15 "Detector Block" of the
792 Basic IC and fasten to the instrument by tightening the
screws in the cable connector (see Fig. 2 ).
4 Connect waste container
x
Lead the outlet capillary of the detector block
38
38 38
38
to a suffi-
ciently large waste container and fix in place.
2.3.2 Connection of syringe and aspirating tubing
For manual filling of the sample loop 22 22 22 22 mounted on the injection valve,
the 6.2816.020 Syringe, the syringe tubing
25
25 25
25
with coupling
24
24 24
24
and the
PTFE aspirating tubing 23 23 23 23 are needed. These accessories are mounted
as follows:
1 Connect syringe to syringe tubing
x
Pull syringe tubing 25 25 25 25 connected to injection valve 22 22 22 22 by
hand out of feedthrough
3333
as far as desired (see Fig. 3 ).
x
Mount a PEEK compression fitting
46
46 46
46
(see section 2.3.4 ) to
the end of the syringe tubing 25 25 25 25 and screw the coupling 24 24 24 24
(6.2744.120) to the compression fitting
46
46 46
46
.
x
Push 6.2816.020 Syringe (without needle) as far as it will go
into the connection of coupling 24 24 24 24 .
2 Install aspirating tubing
x
Pull aspirating tubing
23
23 23
23
connected to injection valve
22
22 22
22
by
hand out of feedthrough 4444 as far as desired (see Fig. 3 ).
2.3.3 Connection of the 6.5324.000 Bottle rack (option)
The optional available 6.5324.000 Bottle rack for supply vessels can be
placed on top of the 792 Basic IC. The accessories include the supply
vessels for eluent (2 L), regeneration solution (1 L) and rinsing solution
(1 L).