Metro Therm SHK 200S, Installation And Operating Manual

Page: 49 / 80

49 SHK 200S
SHK 200S-6
Cooling settings
In the factory settings of the SHK 200S / SHK 200S-6
the cooling is activated, but it requires additional set-
tings to be activated.
To start the cooling, change the parameter "turn on
cooling" to the value above which (regarding out-
side temperature) the cooling should begin. set in
menu 1.9 (settings can be found in menu 1.9.1.2 and
1.9.3.2).
If the average temperature calculated by the "calcula-
tion time" is higher than the set temperature, cooling
according to set in menu 1.9 (settings can be found in
menu 1.9.1.2 and 1.9.3.2).
CAUTION
The settings for cooling should be made based on the
existing CH system.
The above cooling settings can only be edited by qual-
ified personnel.
Factory setting:
IMPORTANT
Incorrect settings in the service menus can damage the
installation, heat pump and indoor unit.
Submenu SERVICE
Menu 5.1 - operating settings
Menu 5.1.1 - hot water settings
Menu SERVICE has orange text and is intended for
the advanced user. This menu has several sub-men-
us. Status information for the relevant menu can be
found on the display to the right of the menus
• operating settings Operating settings for the
control module.
• system settings System settings for the control
module, activating accessories etc
• accessory settings Operational settings for dif -
ferent accessories.
• soft in/outputs Setting software controlled in
and outputs on the input card (AA3) and terminal
block (X2).
• factory setting service Total reset of all settings
(including settings available to the user ) to de-
fault values.
• forced control Forced control of the different
components in the indoor module
• start guide Manual start of the start guide which
is run the first time when the control module is
started.
• quick start Quick starting the compressor.
Go to the main menu and hold the Back button in for 7
seconds to access the Service menu.
Operating settings can be made for the control mod -
ule in the sub menus.
Operating settings can be made for the control mod -
ule in the sub menus.
economy
Setting range start temp. economy: 5 – 55°C
Factory setting start temp. economy: 39°C
Setting range stop temp. economy: 5 – 60°C
Factory setting stop temp. economy: 43°C
normal
Setting range start temp. normal: 5 – 60°C
Factory setting start temp. normal: 42°C
Setting range stop temp. normal: 5 – 65°C
Factory setting stop temp. normal: 46°C
luxury
Setting range start temp. lux: 5 – 70°C
Factory setting start temp. lux: 45°C
Setting range stop temp. lux: 5 – 70°C
Factory setting stop temp. lux: 49°C