Mertz Boxer 999-935, Operator'S Manual

Page: 33 / 84

3-7
Pre-Start Inspection and Operation
Cylinder Lock Installation
1. Start the engine. (See Machine Start-up in this section for engine starting instructions.
2. Fully raise the loader arm.
3. Shut off the engine.
4. While holding the cylinder lock (Item 2,
Figure 3–6 ), pull the safety lock pin (Item 1, Figure
3-6) outwards, releasing the cylinder lock.
5. Install the cylinder lock onto either of the loader arm lift cylinders (Item 3, Figure 3–6 ).
6. Fully reinsert the safety lock pin (Item 1, Figure 3–6 ), securing the cylinder lock in the
support position.
NOTE:
Make sure that the safety lock pin goes behind the loader arm
cylinder.
7. Lower the loader arm assembly until it is supported by the cylinder lock.
Figure 3–6 Safety Lock Installation
Cylinder Lock Removal
1. Start the engine and raise the loader arm to its full height.
2. Shut off the engine.
3. Pull the safety lock pin (Item 1,
Figure 3–6 ) fully outwards.
4. Remove the cylinder lock (Item 2, Figure 3–6 ) and return it to the storage position on one of
the hydraulic lines, such as over the filter return line.
5. Fully insert the safety lock pin (Item 1, Figure 3–6 ) to secure the cylinder lock in the storage
position.
2090