1. Place the motor in the deployed position.
70022
2. After mounting the accessory of choice on the shaft or lower unit of the
motor run the cable on the side of the shaft to the bottom of the 360
breakaway housing.
3. Attach the cable to the bottom of the 360 breakaway housing using the
provided cable tie and screw found in the trolling motor accessory kit.
4. Route the cable from the bottom of the 360 breakaway housing to the top
of the 360 breakaway housing using the cable tie and screw.
5. Insert the cables of the accessory into the front of the cable routing clip
and out of the second slot on the opposite end of the clip.
IMPORTANT: The clip must be within 2.54 cm (1 in.) of the raised part of the
side plate to avoid damage to the clip when stowing and deploying.
TROLLING MOTOR INSTALLATION AND OPERATION
eng
29