Installation Variations
If replacing an existing trolling
motor that uses a 4" hole
pattern
Remove the four screws and starboard side
cover plate from inside of the mount to
uncover the 10.2 cm (4 in.) mounting hole
pattern that matches the legacy MotorGuide
trolling motor mounts.
a -
7.6 cm (3 in.) pattern
b -
10.2 cm (4 in.) pattern
c -
Starboard side cover
IMPORTANT: Use a countersink drill bit or a larger drill bit to countersink the
holes on fiberglass boats to prevent cracking.
4. Drill the mounting holes with a 6 mm (1/4 in.) diameter drill bit. Remove
any debris.
5. Insert the rubber isolators between the base of the mount and the boat
mounting surface.
6. Install the stainless steel washers and nylon locknuts onto the mounting
screws underneath the boat deck. Tighten the screws securely.
b
b
b
b
b
b
aa
a
a
a
a
c
70119
TROLLING MOTOR INSTALLATION AND OPERATION
20
eng