2. Install the tie‑down strap through the slots in the mount, hook‑and‑loop
side down, with the buckle facing toward the outside of the boat.
a -
Tie‑down strap
b -
Slots
c -
Buckle
IMPORTANT: Ensure that the bounce buster contacts the boat on a desired
location prior to drilling holes and mounting the motor. Refer to Bounce Buster
Installation.
IMPORTANT: A minimum of four mounting bolts are required to mount the
trolling motor to the boat. Spread the mounting bolts as far apart as practical
for the most secure mounting.
3. Place the trolling motor on the surface of the boat deck. Use the mount as
a template to mark the locations of the front mounting holes and the rear
mounting holes on the mount.
Installation Variations
For a new boat installation
Use the exposed 7.6 cm (3 in.) hole pattern.
If replacing an existing trolling
motor that uses a 3" hole
pattern
Use the exposed 7.6 cm (3 in.) hole pattern
in the base of the mount.
70015
a
b
b
c
TROLLING MOTOR INSTALLATION AND OPERATION
eng
19