Mercedes-Benz V 200 4MATIC 2015, Operating Instructions Manual

Page: 89 / 360

Convenience opening feature
You can ventilate the vehicle before you start
driving. To do this, the key is used to carry out
the following functions simultaneously:
R
to unlock the vehicle
R
to open the side windows
R
to open the hinged windows
R
to switch on the seat ventilation for the driv-
er's seat
The convenience opening feature can only be
operated using the key. The key must be close to
the driver's door handle.
X
Convenience opening: point the tip of the
key at the driver's door handle.
X
Press and hold the
%
button until the side
windows are in the desired position.
X To interrupt convenience opening: release
the
%
button.
Convenience closing feature
G
WARNING
When using convenience closing, you could
become trapped within the sweep of the clos-
ing window. There is a risk of injury.
Monitor the entire closing procedure when
using convenience closing. When closing,
make sure that no one has any parts of the
body within the closing area.
When you lock the vehicle, you can close the
side windows at the same time.
The key must be close to the driver's door han-
dle.
Observe the notes on the automatic reversing
feature for the side windows (
Y
page 85).
X
Convenience closing feature: point the tip
of the key at the driver's door handle.
X Keep the
&
button pressed until all side
windows are fully closed.
X
Make sure that all side windows are closed.
X
To interrupt convenience closing feature:
release the
&
button.
Resetting the side windows
You must reset the side windows if there has
been a malfunction or an interruption in the volt-
age supply.
X Turn the key to position
2 in the ignition lock.
X Pull the two power window switches and hold
for approximately 1 second after closing the
side window.
X
If the side windows remain closed after the
button has been released, they have been
reset correctly. If this is not the case, repeat
the steps above for the open window.
Problems with the side windows
G
WARNING
If you close a side window again immediately
after it has been blocked or reset, the side
window closes with increased or maximum
force. The reversing function is then not
active. Parts of the body could be trapped in
the closing area in the process. This poses an
increased risk of injury or even fatal injury.
Make sure that no parts of the body are in the
closing area. To stop the closing process,
release the switch or push the switch again to
reopen the side window.
If you cannot completely open or close a side
window:
If there are no objects or leaves in the window
guide that prevent the sliding sunroof from clos-
ing, there has been a malfunction or the on-
board voltage has been interrupted.
X Reset the side window (
Y
page 87).
Side windows
87
Opening and closing
Z