Mercedes-Benz V 200 4MATIC 2015, Operating Instructions Manual

Page: 337 / 360

Partially laden vehicle Fully laden vehicle
Tyre size Front axle Rear axle Front axle Rear axle
205/65 R 16 C 300 kPa
(3.0 bar/
44 psi)
310 kPa
(3.1 bar/
45 psi)
360 kPa
(3.6 bar/
52 psi)
360 kPa
(3.6 bar/52 psi)
225/60 R 16 C 280 kPa
(2.8 bar/
41 psi)
290 kPa
(2.9 bar/
42 psi)
340 kPa
(3.4 bar/
49 psi)
340 kPa
(3.4 bar/49 psi)
225/55 R 17 RF 260 kPa
(2.6 bar/
38 psi)
260 kPa
(2.6 bar/
38 psi)
300 kPa
(3.0 bar/
44 psi)
310 kPa
(3.1 bar/45 psi)
245/45 R 18 RF 260 kPa
(2.6 bar/
38 psi)
260 kPa
(2.6 bar/
38 psi)
310 kPa
(3.1 bar/
45 psi)
330 kPa
(3.3 bar/48 psi)
245/45 R 19 XL 250 kPa
(2.5 bar/
36 psi)
250 kPa
(2.5 bar/
36 psi)
270 kPa
(2.7 bar/
39 psi)
300 kPa
(3.0 bar/44 psi)
Changing a wheel
Interchanging the wheels
G
WARNING
Interchanging the front and rear wheels may
severely impair the driving characteristics if
the wheels or tyres have different dimensions.
The wheel brakes or suspension components
may also be damaged. There is a risk of acci-
dent.
Interchange front and rear wheels only if the
wheels and tyres are of the same dimensions.
! On vehicles fitted with a tyre pressure mon-
itor, electronic components are located in the
wheel.
Tyre-fitting tools should not be applied in the
area of the valve, as this could damage the
electronic components.
Only have tyres changed at a qualified spe-
cialist workshop.
Interchanging front and rear wheels of differing
dimensions can render the general operating
permit invalid.
Always observe the instructions and safety
notes under "Fitting a wheel" (
Y
page 336).
The wear patterns on the front and rear tyres
differ, depending on the operating conditions.
Interchange the wheels before a clear wear pat-
tern has formed on the tyres. The front tyres
typically wear more on the outer shoulder, and
the rear tyres in the centre of the tread.
On vehicles that have the same size wheels and
tyres, you can interchange the wheels every
5,000 to 10,000 km. Maintain the direction of
tyre rotation.
Clean the contact surfaces of the wheel and the
brake disc thoroughly every time a wheel is
interchanged.
Check the tyre pressure and reactivate the tyre
pressure monitor if necessary.
Direction of rotation
Tyres with a specified direction of rotation have
additional benefits, e.g. if there is a risk of aqua-
planing. You will only gain these benefits if the
correct direction of rotation is observed.
An arrow on the sidewall of the tyre indicates its
correct direction of rotation.
You may fit the spare wheel against the direction
of rotation. Observe the time restriction on use
as well as the speed limitation specified on the
spare wheel.
Changing a wheel
335
Wheels and tyres
Z